MALCOM TK-1S
summary
Brief introduction to the characteristics of MALCOM TK-1S adhesion tester：
- Measure the adhesion of solder paste.
- Measurement items: adhesion, impact force and sensor probe immersion.
- Three kinds of immersion methods can be selected to test close to the actual mounting conditions.
- By changing the setting conditions, the difference of adhesion force is fed back to the production site in time.
- (Setting conditions: punching force, punching time, separation speed, immersion amount)
parameter
Specification parameters of Malcom TK-1S adhesion tester：
| model |
TK-1S |
| Weight sensor |
measuring range：0～400gf±2gf Decomposition energy：0.25gf |
| Immersion mode |
(1) Constant pressure immersion method (JIS specification) (2) Quantitative immersion method (3) Fixed-point immersion method (IPC specification) |
| Determination result |
(1) adhesion: T gf (2) Actual punching force: P gf (3) Actual immersion amount: D μm |
| Set conditions |
(1) impact force:-20 ~-400 gf (2) Stamping time: 0.1～99.9s (3) separation speed: 1.0 ~ 10.0 mm/s (constant pressure immersion/quantitative immersion) 2.0 ~ 600.0 mm/min (fixed point immersion)※ (4) Immersion amount: 20 ~ 200μ m (5) temperature: room temperature+10℃ ~ 250℃ |
| weight | About 10kg |
Note: When using the sensor fixed-point immersion method, the immersion speed must be the same as the set value when the separation speed reaches 120mm/min, and it should be noted that the speed above that becomes 120mm/min.
